User manual

Q-Matrix 88
User Manual
User Manual
Q-Tech Commercial Series Q-Matrix 88
9
Local zone source level has three
adjustments, namely:
Gain control for the local source Input on a.
the rear of the Matrix
A Music level control on the Matrix front b.
panel or the remote wall control
A Master level control on the Matrix front c.
panel.
Please Note: The input signal is set at
300mV-1.1v/10K Ohm
7. Remote Control Panel Input
Each of the eight zones can have a remote
control panel connected. The Remote control
Panel will enable the source and volume to be
controlled from a remote location. Each zone
has its own RJ45 input connector allowing for
a Remote Control Panel to be connected for
control over each zone.
Local Source Connections are as follows:
A remote wall panel can be connected 1.
to the Matrix, with only one remote wall
controller able to be connected per
zone.
The remote wall panel will be selectable 2.
on the system. Therefore, selectable
sources will be L (local) as well as
source line1 to 8.
The RJ45 pin assignment
is as follows:
RS485 B1.
RS485 A2.
GND3.
24V (OUT) 4.
GND5.
+ 24V (OUT)6.
SPARE7.
SPAR8.
8. Page
The Zone Page Output Volume Control will
adjust the output paging level for the Zone.
Every Zone has a Page Output Volume
Control which enables the paging level of
each zone to be set independently of other
zones.
9. LF Bass
The Zone LF Bass
of the Zone Output
can be controlled
by adjusting the LF
Bass Level Control.
This Level Control
will provide adjustment of the 100Hz Audio
Frequency by ±10dB.
Every Zone has a LF Bass Level Control which
enables the LF Bass Level of each zone to be
set independently of other zones.
10. Output
Every Zone has an
AUDIO OUTPUT
connector; this should
be connected to the
Audio Amplifier for
the designated Audio
Zone.
Zone Audio Output Connections are as
labeled.
11. Gain
The Zone Gain control
will set the maximum
Source Output Volume
Level for the Zone.
This will ensure the
user cannot adjust the Audio Level too high
using the Master, MIC1 and Music Level
Control Knobs on the Front Panel. Gain will
set the Maximum Output Volume of Line
Source and MIC1. It will have no control over
the Paging Level.
1 2 3 4 5 6 7 8