User manual

Q-Matrix 88
User Manual
User Manual
Q-Tech Commercial Series Q-Matrix 88
19
Connection and Setting
Power Supply
The remote paging console is powered by the Matrix through the RJ45 communication port when
the communication distance is < 50 meters. An extra DC 24V power input is equipped on the back
part of the paging console to supply power when the communication distance is longer than 50
meters.
Connection Between Remote Paging Console & Extension Keypad
The IDE communication cable is used to provide connection between the remote paging console
and the extension keypad as well as between two extension keypads.
Extension Keypad Dip Switch Setting
There are 4 address codes on both remote the paging console and the extension keypad which are
used to identify these.
Please Note: Only one address code switch of each dip switch can be placed in the downward
position. If any of the dip switches are set at different addresses to those shown above, the console
will not operate.
Extension keypad Remote paging Console Connection is made through the supplied 10P IDE
cable. Once either two or three QTEP extension panels are connected, the operation of paging
announcements is the same as described previously for individual zone paging or all call actions.
1 2 3 4
Extension Keypad 2
1 2 3 4
Extension Keypad 3
1 2 3 4
Extension Keypad 1
Extension Keypad
Remote Paging Console
Connection Through
10P IDE Cable