User manual

Q-Matrix 88
User Manual
User Manual
Q-Tech Commercial Series Q-Matrix 88
21
Connection & Wiring
Power Supply
The RJ45 port is used to communicate
between the remote control panel and the
Matrix, it also will be used to supply power
to the panel within 50 meters. A spare DC24V
input is provided for extra power supply to the
remote control for communication distances
longer than 50 meters. The communication
cable preferred is industry standard CAT5
cable.
Local Source Input
The local source input through the dual RCA
aux input connector.
Microphone Input
The 3 pins of the mic input at the rear side
are sent to the PCB board through the
microphone signal input.
Aux Output
Aux output is included in the RJ45
communication port. A spare aux output is
also provided.
Spare AUX Output & Spare 24V DC Input
When the
communication
distance is longer
than 50 meters, this
connection can be
used for additional
power. A second
run of Cat 5 may be
used.
+24V2
GND
GND
GND
Audio -
Audio +
1 2 3 4 5 6
11
10
9
13
14
12
9
Spare AUX Output To AMP
10
Spare 24V DC Input
Extra DC 24V will be needed to power
supply the remote control
11
RJ45 Communication Port
The RJ45 port is used to communicate
between the remote Control panel and the
Matrix. I also supplies power to remote
panels within 50 meters
12
MIC Connector
13
JTAG Connector
It is used to burn program
14
MIC Signal Input
Connector to input microphone signal to
the PCB board