User manual

Q-Matrix 88
User Manual
User Manual
Q-Tech Commercial Series Q-Matrix 88
6
9. Monitor ZONE SELECT
The ZONE SELECT button (9) is used to select
one of the 8 zones to be monitored. Pressing
the zone select button will cycle through all
zones in sequence as follows: 1, 2, 3, 4, 5, 6,
7, 8, and OFF.
A zone can be selected pressing the ZONE
SELECT button. Once the display shows
the desired zone, press the ENTER button to
confirm and change to the selected zone.
Note: The zone will only change after the
ENTER button is pressed, otherwise the
source selection will be returned to its
previous setting after 10 seconds.
The monitor zone function enables the audio
output from a zone to be monitored through
a small speaker on the front panel. This is
particularly useful when controlling the audio
in a remote zone or testing the system.
10. Monitor Zone LED Display
The Single Digit Monitor Zone LED Display
(10) will display the selected zone numbers,
1-8.
11. Monitor Zone Output Level
The 5 LED Monitor Zone Output Level Meter
(11) will provide visual indication of the audio
signal level for a selected zone.
12. Monitor Volume
The Monitor Volume control knob (12) will
control the in-built Monitor Speaker volume
level.
13. ESC
The ESC button (13) is used to cancel the
selection of source select, monitor zone
select and BGM function buttons.
14. ENTER
The ENTER button (14) is used to confirm
selection of source select, monitor zone
select and BGM function buttons.
15. BGM ALL
The BGM ALL button (15) is used to select the
same source for all 8 zones simultaneously.
To confirm the BGM ALL selection, press
ENTER.
Note: The BGM ALL selection will only be
confirmed after the ENTER button is pressed,
otherwise the source selection will be return
to previous setting after 10 seconds.
In the event power is lost, the BGM ALL
selection settings will be saved and the unit
will return to the previous BGM ALL setting
when powered back on.