User Manual

THE NEXT GENERATION IN FLOOD PROTECTION
TM
Activates
when wet!
888-761-4405
QUICKDAMS.COM
INSTRUCTIONS: EACH FLOOD BARRIER:
Place Quick Dams in the path of problem water
Smaller stitched area acts as a wedge & prevents
the barrier from rolling out of position
Quick Dams are activated when exposed to fresh
water and will absorb & swell to create a barrier
During rst activation, you will see white gelled
particles in the stitching areas- this is normal &
naturally decomposes
If a rush of water is expected, pre-soaking the
Quick Dams and stacking them is recommended
Stack Barriers by ipping one over so small
stitched areas are opposite each other, which
creates a at surface to secure the third layer in
place Quick Dams may be left in position for long
term ood protection, up to several months
Quick Dams are resuable - they grow when
exposed to water and will shrink as water evaporates
Quick Dams may not be a solution for all situations
* Not for use with salt water ooding
ONCE ACTIVATED, USAGE OPTIONS:
Leave in position & reuse
Grows when re-exposed to water
Shrinks while evaporating,lasts 6-12 months
Eventually contents degrade
As Quick Dams degrade, a “sliminess” will be present
Allow complete evaporation & reuse
Be sure to keep dry in well ventilated area
Could take 2 + months depending on humidity
Once dry “crunchy” - store away for later use
Speed decomposition for disposal
Leave in direct sunlight for months
Cut open & expose contents to direct sunlight
Soak in salt water
Simply throw in trash
Quick Dams are safe, non-toxic
& environmentally friendly.
Starts as: 9in wide & either 5ft, 10ft or 17ft long
Grows to: 3.5in high & 34lbs, 68lbs & 116lbs
respectively
PROPER FLOOD BARRIER STACKING:
Pyramid: Overlapped
and Stairstepped
For proper stability,
width should be 3 times height
Patent Pending
FLOOD
BARRIERS

Summary of content (1 pages)