Full Product Manual

Flood Gate Manual | www.quickdams.com

GENERAL MAINTENANCE AND INSTALLATION

Removing the clamp

Keep the allen screws and allen wrench in a safe place as they will

be needed to secure the Stanchion to the Base in the event of

a ood.

Maintaining the Base

1. There are (4) 1/2 in. - grub screws with every Stanchion.

These must be coated with a waterproof grease or anti-seize

compound and screwed into the holes on each plate. This will

protect the threads in the plate and allow trafc to move

across the anchor plate without damaging the threads

(See illustration Q).

2. These plugs should be ush with the top of the Base and no

deeper. They should also be re-greased periodically and after

every use to ensure they will come out when needed.

Before Installing the Stanchion

IMPORTANT: To prevent any leaking between the top of the Base and the bottom of the

Stanchionthereisamachined3/16”groovewhichshouldbelledwithsiliconecaulkto

add additional sealing (See illustration R).

Maintaining the sealing surfaces

Always keep the top of the Base and the bottom of the Stanchion clean and free of nicks and dents

as these are critical sealing surfaces.

SEALING

GROOVE

SEALING

GROOVE