Full Product Manual

14
Flood Gate Manual | www.quickdams.com
AFTER-USE
Flood Gate Maintenance Instructions
1. Return the horizontal and vertical operating mechanisms to their closed position.
2. Remove the unit from its position.
3. Remove the sleeve and examine for damage caused by stress, use or wear and tear.
Repair or replace as necessary.
4. The sleeve can be hand washed in warm water up to 104° F (40° C). Rinse in cold water and hang
to dry in shaded area. DO NOT TUMBLE DRY.
5. Dry off excess moisture from the metal frame. Examine for damage caused by stress, use or wear and
tear. Apply rust proong oil or grease to all expandable mechanisms.
6. Once all parts of the unit are dry, the unit can be stored for future use.
Storing your Flood Gate
1. Store the unit in a secure location and only allow access by a responsible adult.
2. The unit should be stored in its closed and upright position. DO NOT STORE IN AN EXPANDED STATE.
3. Store the unit and its accessories in a dry and well ventilated area. DO NOT STORE IN
DIRECT SUNLIGHT.
4. DO NOT EXPOSE THE PRODUCT TO EXTREME TEMPERATURES AND KEEP AWAY FROM
OPEN FLAMES.
5. Place the unit in storage in it’s normal upright position, keeping the sleeve separate & at to
maintain it’s shape.
6. If you are storing more than one unit and do not intend on using the original packaging, the gates must
be stored face to face (The face as shown in Diagram A).
7. DO NOT STORE FACE TO BACK OR BACK TO BACK AS THIS CAN DAMAGE THE PRODUCTS.
8. Review the unit and its mechanisms periodically to ensure that the conditions of storage have not
reduced its effectiveness.
TERMS & CONDITIONS
Flood Gate is intended to be used as outlined in this document and other Absorbent Specialty Products (ASP) literature. Data and
information provided in this document is for general information purposes only. Conditions for each use of the Flood Gate will vary
and are beyond the control of ASP. ASP cannot guarantee desired results. When purchasing this product from ASP, you agree to as-
sume all risks that may arise from ownership, installation, and use of the Flood Gate and agree to release ASP from any and all claims
brought by any person or entity against ASP related to and/or arising from your ownership, installation, and/or use of the Flood Gate.
ASP shall not be liable for any improper or incorrect ownership, installation or use of this product and assumes no responsibility for
anyone’s ownership, installation or use of this product. In no event shall ASP be liable for any direct, indirect, incidental, special, ex-
emplary or consequential damages (including, but not limited to: procurement or substitute goods or services; loss of use or prots;
or business interruption) however caused and on any theory arising in any way out of the use of this product, even if advised of the
possibility of such damage. This disclaimer of liability applies to any damages, injury or death, whether based on alleged breach of
contract, tortuous behavior, negligence or any other cause of action, including and not limited to damages or injuries caused by any
failure of performance, error, omission, defect or delay in operation.
LIMITED WARRANTY
ASP warrants this product and components to be free from defects in material and workmanship for a period of one (1) year from
date of shipment. If within the term of this warranty, if any Flood Gate component is found to be defective upon inspection by an
authorized Flood Gate representative, ASP will replace or repair, at ASP’s discretion, any part found to be defective. Unauthorized
modication of this product voids this limited warranty. The neoprene sleeve is considered a “wear-item” and is not covered under
this warranty. Replacements can be purchased from ASP. Moving parts must be properly maintained prior to storage.
To make a claim under this warranty, contact ASP at this address:
Absorbent Specialty Products | 1 John C. Dean Memorial Blvd. | Cumberland, RI 02864 | 888-761-4405 | [e-mail]