Product Manual

BEHAVIORS AND STRETCHING OF THE PARTITIONS
In this illustration, it can be seen how we each partition behaves to the increasing water pressure inside the
Water-Gate. These partitions prevent the upper canvas from tipping backwards. Via the components principle of
equilibrium of forces. The partitions of the Water-Gate are made of non-expandable polyethylene; A rigid material
recognized for its strength. Thus, due to this concept, it is impossible that the distribution of tensions between
each partition.
PRESSURE EXERCISED ON ANY PART OF THE PARTITIONS
In this illustration, we can observe the pressure exerted on each part of the partition. The figure uses abstract
units of tension to demonstrate the distribution of the applied forces. The red indicated the robustness to tension
applied on each partition.
We can observe an area which has a point of force superior to any other. It is here on the partitions that receive
the most tension. It is also at a point which our calculations of strength and sturdiness have been made.
The tensions inscribed on the canvas are figures based on our expertise and our observations.
0
1
2
3
4
5
6
7
8
9
10
1.0 3.0 4.0 5.0 5.5 6.0 6.0 6.0 6.0 6.0 6.5
19.