Instructions / Assembly

INSTRUCTIONS

Install a Quick Door Hanger bracket directly behind the center of each hinge with

the ½” screws (provided), make sure the bracket’s clearance hole lines up

directly behind one of the center screws of each hinge (FIG A). Install the other

three Quick Door Hanger brackets directly across from the hinges on the

opposite side of the door (FIG B).

Using a 6’ or 4’ level, draw a “LEVEL” line all the way down the drywall

approximately ½” in from the rough opening on the hinge side. Must be a

“LEVEL” line.

Place the door into the opening. Starting with the top bracket on the hinge side

of the door, line up a reference notch on the bracket with the level line that was

drawn in step 2 (FIG C). Screw into place using drywall screw. Use the same

reference notch when screwing in the next 2 brackets on the hinge side. Door is

now perfectly level. Screw in the remaining 3 brackets on the latch side, starting

on the top, make sure the reveal (gap between door and door frame) stays the

same. Check door operation. For added support, remove a center screw from

each of the hinges and replace with a long set screw (2”or longer) that goes

through the hinge, bracket clearance hole, and into the wall stud.* Trim/Casing

can now be installed directly over brackets to complete installation.

Or view the video at

www.TheQuickDoorHanger.com/Promo

* Note: Before the installation of the trim/casing and long hinge screws, you will notice

the door can be slightly moved by bending the brackets, this is not a defect, this is to

accommodate any imperfections in the wall, if needed. This movement will go away

after the installation of the trim/casing, resulting in a very strong, sturdy, professional

door installation.

QR smart phone scan

PRODUCT VIDEO

Scan Me!!!

Need a Smart Phone

QR barcode scanner App.

These instructions are for interior pre-hung doors. For installation

instructions without drywall yet installed, or other types of doors

using these brackets (Exterior, Double/French, Split-jamb, slab), visit

us at: www.TheQuickDoorHanger.com

PAGE 1
INSTRUCTIONS Install a Quick Door Hanger bracket directly behind the center of each hinge with the ½” screws (provided), make sure the bracket’s clearance hole lines up directly behind one of the center screws of each hinge (FIG A). Install the other three Quick Door Hanger brackets directly across from the hinges on the opposite side of the door (FIG B). Using a 6’ or 4’ level, draw a “LEVEL” line all the way down the drywall approximately ½” in from the rough opening on the hinge side.