Installation Guide

Oct -2021, Rev 12
2
Place the frame clamp over the edge of the
module frame, and in front of the module level
electronic mounting bracket. Slide the assembly
up and to the le to engage cap screw into frame
clamp slot.
Tighten the cap screw with a half-inch socket and
torque wrench to a torque of 15 foot-pounds.
Neatly coil the wires and clip to module frame.
2
3
5
4
6
1
Accessory Frame Bracket | QMAFB
Installation Tools Required: PV wire clips, 1/2" socket and torque wrench.
In a standard landscape or portrait array, the
Accessory Frame Bracket should be installed at
least 5 inches from the edge of the module and
at least 1 inch in from the edge of the module
junction box.
With the cap screw threaded into the bracket,
slide the cap screw into the slot on the module
level electronic mounting bracket with the bracket
behind the module level electronic mounting
bracket.
Slide this assembly onto the module frame with
the bracket behind the module frame, the module
level electronic mounting bracket in front of the
module frame.
Installation Instructions