Brochure

Aug-2016, Rev 11BI 7.2.3-37_1
Slide this assembly onto the module frame with
the bracket behind the module frame, the module
level electronic mounting bracket in front of the
module frame, and the bracket clamp in front of
the module level electronic mounting bracket.
Slide the assembly up and to the le to engage
cap screw into bracket clamp slot.
Tighten the cap screw with a half-inch socket and
torque wrench to a torque of 15 foot-pounds.
Neatly coil the wires and clip to module frame.
2
3
5
4
6
1
Accessory Frame Bracket | QMAFB
Installation Tools Required: PV wire clips, 1/2" socket and torque wrench.
In a standard landscape or portrait array, the
Accessory Frame Bracket should be installed at
least 5 inches from the edge of the module and
at least 1 inch in from the edge of the module
junction box.
Place the bracket clamp over the edge of the
module frame.
With the cap screw threaded into the bracket,
slide the cap screw into the slot on the module
level electronic mounting bracket with the bracket
behind the module level electronic mounting
bracket.
Solar Edge P300 and P400 optimizers are speci c to landscape and portrait orientations; use the correct model for your system orientation.
Installation Instructions