QMCMT - Conduit Mount for Tile for Curved or Flat Tiles Installation Instructions
Instructions: Conduit Mount for Tile Installation Tools Required: 7/16" socket wrench. 1 2 thinner than 1" Determine the tile that the mount will be installed on. Remove the tile or tiles from the course immediately above that tile. Hook the top clamp over the top edge of the tile. 4 Insert the 4" tap bolt through the slot on the bottom clamp and into the threaded hole on the end of the top clamp. Use a 7/16" socket wrench to thread the screw.
BI 7.2.3-39 Apr-2019, Rev 2 5 WRITTEN PERMISSION OF QUICK MOUNT PV IS PROHIBITED. COPYRIGHT © 2019 QUICK MOUNT PV 4 3 REVERSIBLE. ATTACH THIS LEG TO TILES LESS THAN 1" THICK 4 3 DO NOT SCALE DRAWING DESCRIPTION 1 1 1 1 QTY. 2 DIMENSIONS ARE IN INCHES TOLERANCES: FRACTIONAL 1/8 TWO PLACE DECIMAL .19 THREE PLACE DECIMAL .094 UNLESS OTHERWISE SPECIFIED: AAP 1 4/5/2019 WEIGHT: 0.
RESPECT THE ROOF BI 7.2.3-39 925-478-8269 | www.quickmountpv.com | info@quickmountpv.com 2700 Mitchell Dr. | Walnut Creek, CA 94598 Apr-2019, Rev 2 © 2016 by Quick Mount PV. All rights reserved.
