Installation Guide











 






%27+6,'(62)6/276(55$7('

+(;'5,9(216(76&5(:
6/,'(72'(6,5('
/2&$7,21
,7(012 '(6&5,37,21 47<
 %$6(3/$7(48,&.+22.86$:,'(70,// 

/$*6&5(:+(;+($'[66 

48,&.+22.86$9(57,&$/70,// 

6(76&5(:+(;62&.(7;66 

68%)/$6+,1*48,&.+22.86$9%$6(;;
0,//


'21276&$/('5$:,1*
6+((72)
5$'
6&$/( :(,*+7
5(9
$
6,=(
7,7/(
'$7(
'5$:1%<
',0(16,216$5(,1,1&+(6
72/(5$1&(6
)5$&7,21$/

7:23/$&('(&,0$/

7+5((3/$&('(&,0$/

35235,(7$5<$1'&21),'(17,$/
7+(,1)250$7,21&217$,1(',17+,6'5$:,1*,67+(62/(3523(57<2)48,&.0281739$1<5(352'8&7,21,13$5725$6
$:+2/(:,7+2877+(:5,77(13(50,66,212)48,&.0281739,6352+,%,7('





81/(6627+(5:,6(63(&,),('

40&7+48,&.+22.86$
&859('7,/(02817

Quick Hook – Curved Tile Mount QMCTH
Notes:
1) Thread must be embedded in a rafter or other structural roof member.
2) See IBC for required edge distances.
IMPORTANT: To maintain waterproong of substrate it is important to make sure the aluminum sub-ashing is properly placed over the base plate and under the
course of paper above. If the paper above does not reach, due to layout, place an additional piece of roong paper over the sub-ashing and under the next course
of paper above. (See instructions on reverse)
®
BI 7.2.3-16
Nov-2013, Rev 7
1 of 3
Quick Hook USA Failure Test Results
Average Ultimate Load Capacities (lbf) in Douglas Fir
Conguration Source Document
Pullout Compression Shear Parallel to
Rafter
Shear Perpendicular
to Rafter
Centered: All base plate sizes with hook positioned
directly over the lag screws (see Appendix A & B of
referenced report for test setup)
AME Report #112640C "Quick Hook USA-Flat Tile
Mount" with 1.5 Base Plate
This report shows results for Quick Hook USA, both
Flat and Curved Tile models, when the hook is posi
-
tioned directly over the lag screws
876 685 1058
583
Offset 4.5" Base Plate: 4.5" wide base plate with
hook positioned at opposite end of base plate from lag
screws (see Appendix A & B of referenced report for
test setup)
AME Report #112640C "Quick Hook USA-Curved Tile
Mount with 4.5" Base Plate
This report shows results for our Quick Hook USA-
Flat Tile Mount
1084 712 1219
532
Offset 6" Base Plate: 6" wide base plate with hook
positioned at opposite end of base plate from lag
screws (see Appendix A & B of referenced report for
test setup)
AME Report #112640C "Quick Hook USA-Curved Tile
Mount with 6" Base Plate
This report shows results for our Quick Hook USA-
Curved Tile Mount
1246 692 1341
584