Installation Guide

Apr-2016, Rev 7BI 7.2.3-7 BI 7.2.3-7
You are now ready for the rack of your
choice. Follow all the directions of
the rack manufacturer as well as the
module manufacturer.
All roo ng manufacturers’ written
instructions must also be followed
by anyone modifying a roof system.
Please consult the roof manufacturer's
specs and instructions prior to
touching the roof.
Using drill with 7/32" bit, drill pilot hole into roof
and rafter, taking care to drill square to the roof.
Do not use mount as a drill guide. Drill should be
‘long style bit' aka ‘aircraft extension bit’ to drill a
3" deep hole into rafter.
Clean off any sawdust, and  ll hole with sealant
compatible with roo ng materials.
Slide  ashing into position. Prepare hanger bolt
with hex nut and sealing washer. Insert into hole
and drive hanger bolt until QBlock stops rotating
easily. Do NOT over torque.
Insert EPDM rubber washer over hanger bolt into
block.
2
3
5
4
6
8
7
1
Classic Composition Mounting Instructions
Installation Tools Required: tape measure, roo ng bar, chalk line, stud  nder, caulking gun, sealant compatible with roo ng materials,
drill with 7/32" long-style bit, drill or impact gun with 1/2" deep socket.
Locate, choose, and mark centers of rafters to be
mounted. Select the courses of shingles where
mounts will be placed.
Carefully lift composition roof shingle with roo ng
bar, just above placement of mount. Remove nails
as required. See "Proper Flashing Placement" on
next page.
Insert  ashing between 1st and 2nd course. Slide
up so top edge of  ashing is at least 3/4" higher
than the drip edge of the 3rd course and lower
 ashing edge is above the drip edge of 1st course.
Mark center for drilling.
Using the rack kit hardware, secure the racking
(L-foot) to the mount using torque specs from
racking manufacturer. If racking manufacturer does
not specify torque setting, tighten to 13 ft.-lbs.
WARNING: Quick Mount PV products are NOT designed for and should NOT be used to anchor fall protection equipment.
3rd course
1st course
3rd course
2nd course