User manual
Transponder Access Control Kit
Version: 1.0 3
(2) Key “1”: register cards in continuous way
Press “1” → continuously presenting the unregistered card → press “ENT” to confirm → press
“9” to exit
The system will give a number to each card. The original password is “888888”. Such
password can only be used for Card and Password Mode.
If there is no card in the system, the card number will start from “0001” and increase
gradually. The largest number cannot exceed “6399”.
If the registered already exist, the number will increase from the number of previous
registered cards (including the deleted cards).
If add successfully, the buzzer will make two short sound “di di”, otherwise, make a
long sound “di”.
To be able to delete cards without presenting it is strongly recommended to write this
number on the card or make a similar notice.
(3) Key “2”: register a single card (allow registering card continuously)
Press “2” → present the card → input the 4-digit user number → press “ENT” →present
another card →input the 4-digit user number → press ‘ENT” (…..continuously register cards)
→ press “ENT” →press “9” to exit
The system will give a default password “888888” to each card. This password can
only be used in the Card and Password Mode.
If the card has already existed, the buzzer will make a long sound “di”. Then you can
present another card. If the inputted number has already existed, the buzzer will make
a long sound “di”. Then you can input another number.
(4) Key “3”: delete the registered card
Delete card by presenting: Press 3, 0 → present the card →present another card
(Continuously present the card that need to be deleted) → press “ENT” → press “9” to exit
Delete by user number: Press 3, 1 → input the user number → press “ENT” → input another
one→ press “ENT” (continuously delete many user numbers) → press “ENT”
→ press “9” to exit
Delete all cards: Press 3, 2 → input “9999” → press “ENT” →press “9” to exit
(5) Key “4”: Door open mode setting
Card or password: Press 4, 0 → press “ENT” →press “9” to exit (that is the factory default
mode)
Card and password: Press 4, 1 → press “ENT” → press “9” to exit
Password only : Press 4, 2 → press “ENT” → press “9” to exit