User manual

Transponder Access Control Kit
Version: 1.0 5
Operation Example
1. Setting New program password ‘789000’
Firstly, enter the program mode press “ENT” 4 times → input password “123456” →
press “ENT” again( green light flashes) → press “0” → input the program password “789000”
→ press “ENT” → input the password “789000” again
Then press “9” to exit, the default password “123456” turns to “789000”.
Please remember the modified program password. It has to be used to enter the
program mode later.
2.Continuously presenting cards to register
Firstly, enter the program mode press the “ENT” 4 times → input password “123456”
→ press “ENT” again( green light flashes) → press “1” → present new cards(after presenting
all the needed cards → press “ENT”
Then press “9” to exit, the registered card can open the door now.
3. Continuously register two cards, “0088” “0099”
(allowing register many cards continuously)
Firstly, enter the program mode press the “ENT” 4 times → input password
“123456” → press “ENT” again( green light flashes) → press “2” → present the new cards →
input the number “0088” → press “ENT” →present the second card → input the number
“0099” → press “ENT” → press ‘ENT’ once again
Then press “9” to exit, card “0088” and card “0099” can open the door.
4. Delete cards according the card number, e.g. delete the card “0088” and the card
“0099”
Firstly, enter the program mode press the “ENT” 4 times → input password
“123456” → press “ENT” again (green light flashes) → press “3” → press “1” → input
“0088” → press “ENT” → input ‘0099’ →press “ENT” → press ‘ENT’ once again
Then press “9” to exit, card “0088” and card “0099” cannot open the door now. (Deleting
multiple cards means that you can input number one by one. Then, press “ENT”. In this case,
you can delete multiple cards. After confirming, press the “ENT” once again.)
5. Setup the opening mode as presenting cards
Firstly, enter the program mode press the “ENT” 4 times → input password
“123456” → press “ENT” again (green light flashes) → press “4” → press “0” → press “ENT”
Then press “9” to exit, the opening mode has been changed to Card or Password Mode.
6. Setup the opening password as “147258”
Firstly, enter the program mode press the “ENT” 4 times → input password
“123456” → press “ENT” again( green light flashes) → press “6” → input “147258” → press