User manual

Transponder Access Control Kit
Version: 1.0 6
“ENT” → press “147258” again → press “ ENT” once again
Then press “9” to exit, press “147258”, then press “ENT” to confirm, and you can open the
door now.
7. Setting new password ‘88899’ in Card and Password Mode (should operate it in the
Card and Password Mode)
Press “9” → presenting the card (previous registered card) → input the original password
“888888” (the original program password. If you have modified it, please use the modified one
to operate the next step.) The red light and the green light flash one after another → input the
new password ‘888999’→ press “ENT” → press ‘888999’ again → press “ENT”
Special case and faults Judgment
1. External readers
1: When use the external readers to register and delete cards, external readers have video
and audio indication, so please take attention to that when presenting another card.
2: If the external reader has no above indication, please wait 2-3 seconds to present after the
first one.
3: If have to set card number when register cards for external readers, you can only set serial
number on the master controller.
4: Support external keyboard readers. You can also input password to open the door via it.
2. Light change indication
1: According to the changes of the red light, you can know current opening mode, which can
be divided into 3 cases:
Red light always on card or password mode
Red light flashes every 0.5 second card and password mode
Red light flashes every 1 second password mode
2: If red light and green light are on at the same time, it means that the relay is closed and the
output is trigger mode.
3. Normal open/close under special conditions (presenting cards to open or
close, the relay will have no auto response)
Enter the Program Mode, set 99 seconds opening time, the controller relay’s output turns to
trigger mode. That is to say, when presenting the card to open the door, the lock remains open.
When presenting the cards again, the lock remains close.
4. Only the card can open the door, or only the password can open the door
1: Only card can open the door
Firstly, set the opening mode as Card or Password Mode. Then set blank opening password.
2: Only password can open the door
Set the opening mode as Password Mode. There is no response when presenting the card