Owner`s manual

122143 Rev. D

QRI

E. WHEEL LOCKS

Quickie QRi Swing-Away and Quickie QRi Fixed Front wheelchairs are shipped with one of four types of wheel

locks. Wheel locks are installed at the factory unless you have requested otherwise.

Use a torque setting of 100 in.-lbs. when setting up wheel locks.

1. High-Mount Push-to-Lock or Pull-to-Lock ,

Wheel Locks Adjustment

a. Using a 5mm Allen wrench, turn one of the screws (A) in the clamp counterclockwise one-quarter turn.

b. Repeat the same process with the second of the two screws.

c. Alternately loosen the screws (two turns each) until both screws are removed.

d. Slide clamp toward the rear wheel until the wheel lock is embedded into the tire to prevent wheel move-

ment, when in the locked position.

e. Tighten screws to 144 in-lbs. (16.3 Nm).

2. Ergo Scissor Wheel Locks or Compact Wheel Locks

Loosen the screws (B) on the bottom of each clamp using a 5mm Allen wrench. Slide assembly toward rear

wheel until clamp embeds into tire to prevent wheel movement when in locked position. Adjust angle position.

Tighten screws to 144 in-lbs. (16.3 Nm).

NOTE–

Clamp and wheel lock may need to be rotated to clear frame tubing.

F. ANTI-TIP RECEIVER

Sunrise Medical recommends anti-tip tubes for all wheelchairs. Use torque setting of

100 in-lbs. (12 Nm) when installing anti-tip tubes receivers.

1. Attaching Anti-tip Receiver

a. Slide both Anti-tip receivers (G) onto Camber tube and attach hardware (H) to secure the receiver to the

chair.

d. Tighten all screws (H) and attach camber tube with Anti tip receivers to the wheelchair frame

G. CASTERS

Adjusting Caster Angle

For optimum performance, the caster housing should always be at a 90 degree angle to the floor (perpendicular

to the ground). This adjustment is made with an eccentric (offset) attachment bolt mechanism.

a. To change the angle, place the chair on a flat surface (such as a table).

b. Remove the nuts (D) from the caster plate (E), You do not have to completely remove the bolts. The cast-

er plate is slotted at the top and bottom for adjustment purposes, and is now free to be adjusted.

c. Place a large square against the table surface and the front surface of the caster housing.

d. By rotating the eccentric washers (F) independently you can align the caster stem

perpendicular to the floor surface.

e. Re-attach the nuts, and tighten to 75 in-lbs.

f. Repeat the process for the other caster.

2827

3130

+/- 1°

IX. DEALER SERVICE AND ADJUSTMENT