Owner`s manual

Quickie SALSA 13
ENGLISH
4.31 Lap belt
The lap belt kit. (Fig. 13).
Fastening the lap strap.
Insert the 3 prong male buckle
into the female buckle until a
click is heard (Fig. 14)
To fit the lap strap.
Place the strap loosely across
the seat with the buckle closed..
(Fig. 15)
Pass the other ends of the strap
through the gap between the
backrest posts and the backrest
upholstery as shown. (Fig. 16)
Ensure that the adjusters &
buckles can be accessed & the
strap is not twisted. Fit the eyelet
over the rearmost bolt. Fit the
plain washer, sprung washer
& nut. Tighten with a 13.0mm
spanner. Repeat for the other
side. (Fig 17)
Ensure that the lap strap is tight
enough to provide comfortable
support. A simple measure is to
keep a hands thickness between
the body and lap strap. For
safety, check the tension on the
lap strap at least once day. (Fig
18)
Generally, the lap belt should be
fixed so that the straps sit at an
angle of approximately 45° (Fig.
19), and when correctly adjusted
should not allow the user to slip
down in the seat.
Warning - Always make sure that the lap
strap is correctly secured and adjusted
prior to use.
A loose strap could cause the user to slip
down and cause serious injury.
Check lap strap and securing components
at regular intervals for any signs of fray
or damage. Replace if necessary
When servicing, check for correct
operation of the release buckle and for any signs of wear on the
material or plastic brackets
4.32 VR2 Controller (Fig. 20)
Avoid knocking your control system and especially the joystick.
Be careful not to strike obstacles with the control system or
joystick when you drive. Never drop the control system.
When transporting your wheelchair, make sure that the control
system is well protected. Avoid damage to cables.
To improve the reliability of the control system keep exposure to
extreme conditions to a minimum.
Do not expose your control system or its components to damp for
prolonged periods. If your control system becomes contaminated
with food or drink clean it off as soon as possible.
Controller precautions for use
In the event of the wheelchair moving in an unexpected way
RELEASE THE JOYSTICK. This action will stop the wheelchair
under any circumstances
Do not operate the control system if the wheelchair behaves
erratically or shows abnormal signs of heating, sparks or smoke.
Turn the control system off at once and consult your Sunrise
Medical Authorised Dealer.
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 19
Battery Level Indicator On/Off Button
Horn
Speed Indicator
Speed Buttons
Joystick
Fig. 17
Fig. 18
Fig. 20