Owner`s manual

Rotate the axle bracket (Standard)

Using the quick-release axles, take the wheels out of the

axle plug / sleeve.

Undo the screws (1) and remove the axle brackets (2) on

both sides of the wheelchair. Rotate the axle bracket by

180° and refit it into the axle bracket (3) on the opposite

side. Please note that the axle bracket has an

asymmetrical shape. The adjustment offers changes in

the centre of gravity in 2 cm steps. Always use the given

torque (Fig. 6.22).

In addition, the standard axle bracket offers a second

position for fitting the quick-release adapter. When the

wheelchair is delivered, this position is covered with a

sleeve. To use this position, please undo the two screws

(2). Then swap the quick-release adapter (3) and the

sleeve and re-tighten both Allen screws (2) (Fig. 6.22).

Please note that the key surfaces on the quick-release

adapter should always point inwards and select the

wheelbase as desired (see width adjustment of the rear

wheelbase). Always use the given torque For centre of

gravity adjustment, please see the technical specifications

section at the end of these Directions for use.

Rotate the axle bracket (lightweight)

Using the quick-release axles, take the wheels out of the

axle plug / sleeve.

Undo the screw (1) and remove the axle brackets (2) on

both sides of the wheelchair. Rotate the axle bracket by

180° and refit it into the axle bracket (3) on the opposite

side. Please note that the axle bracket has an

asymmetrical shape. The nut surface (4) must always

face outwards. The adjustment offers changes in the

centre of gravity in 2 cm steps. Always use the given

torque (Fig. 6.23/6.24).

Fig. 6.22

Fig. 6.23

Fig. 6.24