Quickie ® Z-500 SUPPLIER: THIS MANUAL MUST BE GIVEN TO THE RIDER OF THIS WHEELCHAIR. RIDER: BEFORE USING THIS WHEELCHAIR READ THIS ENTIRE MANUAL AND SAVE FOR FUTURE REFERENCE.
I. Introduction 3 SUNRISE LISTENS Thank you for choosing a Quickie wheelchair. We want to hear your questions or comments about this manual, the safety and reliability of your chair, and the service you receive from your Sunrise supplier.
II. 4 I. II. III. IV. V. Ta b l e of Contents INTRODUCTION..................................................................................... TABLE OF CONTENTS.............................................................................. YOUR CHAIR AND ITS PARTS .................................................................. NOTICE - READ BEFORE USE ................................................................... EMI (ELECTROMAGNETIC INTERFERENCE)...............................................
III. 6 Yo u r Chair & Its Parts 1 2 7 3 8 9 10 4 5 15 6 13 14 Quickie 1. Stroller handle 930578 Rev. A 11 12 Z-500 8. Armrest 2. Solid back 9. 3. Joystick 10. Backrest pivot plate 4. Swing-away hanger 11. Motors 5. Footplate 12. Battery boxes 6. Swing-away release latch 7. Tilt-in-space mechanism release lever 13. Caster tire Strut tube 14. Caster housing III. Yo u r Chair & Its Weight 65 lbs.
I V. 8 Notice– Read Before Use V. EMI (Electromagnetic Interference) 9 A. CHOOSE THE RIGHT CHAIR & SAFETY OPTIONS Sunrise provides a choice of many power wheelchair styles, sizes and adjustments to meet the needs of the rider. However, final selection of a wheelchair rests solely with you and your health care professional. Choosing the best chair for you depends on such things as: 1. Your size, disability, strength, balance and coordination. 2. Your intended use and your level of activity. 3.
V. 10 EMI (Electromagnetic Interference) 2. Medium-Range Mobile Transceivers: These include two-way radios used in police cars, fire trucks, ambulances and taxi cabs. The antenna is usually mounted on the outside of the vehicle. 3. Long-Range Transceivers: These include commercial radio and TV broadcast antenna towers and amateur (HAM) radios. NOTE– The following are not likely to cause EMI problems: Lap-top computers (without phone or fax), Cordless phones, TV sets or AM/FM radios, CD or tape players.
VI. 12 General Wa r n i n g s VI. General Wa r n i n g s 13 C. WEIGHT LIMIT Heed all warnings in this section. If you fail to do so a fall, tip-over or loss of control may occur and cause severe injury to your or others. A. NOTICE TO RIDER 1. Before using this chair, you should be trained in its safe use by your health care professional. 2. Every wheelchair is different. Take the time to learn the feel of this chair before you begin riding. 3.
VI. 14 General Wa r n i n g s 1. If you modify or adjust this chair it may increase the risk of a fall or tip-over. 2. Modifications unauthorized by Sunrise constitutes remanufacturing of the wheelchair. This voids the warranty. The rider then assumes all future liability for the wheelchair. H. WHEN SEATED IN A PARKED WHEELCHAIR 1. Always turn off all power to your chair when you are parked, even for a moment. This will prevent: •Accidental movement from contact with the joystick by you or others.
VI. 16 General Wa r n i n g s To Reduce The Risk Of A Fall Or Tip-Over: 1. Consult your supplier for information on modifications authorized by Sunrise before you modify or adjust this chair. NOTE– You may need to make additional changes to correct the center of balance. 2. Use extreme care until you know the balance points of this chair and how to avoid a fall or tip-over. N. TRANSFERS It is dangerous to transfer on your own. It requires good balance and agility.
VI. 18 General Wa r n i n g s Q. OBSTACLES Obstacles you may have to overcome in daily use include door thresholds, lifts, ramps and hazards such as potholes and broken pavement. These can damage your chair and may cause a fall, tip-over or loss of control. 1. Be aware that thresholds are very dangerous. (Even a small change in height may stop a caster wheel and cause your chair to tip). You may need to: •Remove or cover threshold strips between rooms. •Install a ramp at entry or exit doors. 2.
VI. 20 General Wa r n i n g s U. RAMPS AT HOME & WORK Make sure ramps meet all Building Codes for your area. 1. For your safety, have a licensed contractor build or remodel ramp to meet all standards. 2. NOTE– The proper design will vary, depending on such things as: the length and height of the ramp; the need for an intermediate platform; landing size; doors and the direction of swing; and whether the ramp includes a turn or angle. At A Minimum: 1.
VII. 22 Wa r n i n g s : Components & Options VII. Wa r n i n g s : Components & Options 23 F. FOOTRESTS If you use parts or make changes not authorized by Sunrise it may create a safety hazard and will void the Warranty. A. ANTI-TIP LEVERS Never remove or alter anti-tip levers. They help keep your chair from tipping over backward in normal use. Make sure rubber rollers are in good condition. B. ARMRESTS Armrests detach and will not bear the weight of this chair. 1.
VII. 24 Wa r n i n g s : Components & Options J. POSITIONING BELTS (OPTIONAL) Use a positioning belt only to help support your posture. Improper use of such belts may cause severe injury or death. 1. Make sure you are not at risk to slide down in the wheelchair seat. If this occurs, you may suffer chest compression or suffocate due to pressure from the belt. 2. A pelvic wedge or a similar device can help keep you from sliding down in the seat.
VIII. 26 Tips For Attendants 1. Persons who help a rider do one of the following tasks should review and heed the warnings “Notice to Attendants” and all warnings in this Manual for that task. 2. The “Tips” that follow are suggestions only. Be aware that you will need to learn safe methods best suited to the rider and to your abilities. Consult your health care professional for instructions. A. TO CLIMB A CURB OR SINGLE STEP IX. Set-Up, Adjustment & Use 27 NOTES 1.
IX. 28 Set-Up, Adjustment & Use IX. Set-Up, Adjustment & Use CHECK-OUT B. 90° FOOTBOARD Be sure this chair performs to your chosen operational settings. If it does not, turn the chair off immediately and reprogram with the Quickie QTRONIX Programmer. If you do not own a Quickie QTRONIX Programmer have your supplier reprogram your wheelchair as needed. Or, you can order a Quickie QTRONIX Programmer for your own use, from your supplier. 1. Height-Adjustment a.
IX. 30 Set-Up, Adjustment & Use B Elevating Legrests B & Use 31 Adjustment a. To retract joystick, push outward on the inside of joystick. b. Push joystick away from front of armrest until it locks into retracted position. c. To return to forward position, push joystick forward until it locks into place. H. SOLID BACK AND SEAT INSERT 1. To Connect a. Line up small cylindrical connector with its receptacle on the rear of the joystick. b. Push in firmly. 2. To disconnect 1. Installation a.
32 IX. Set-Up, Adjustment & Use To tighten or loosen the fit of the outer armpost in the receiver: a. Loosen the four bolts on the sides of the receiver. b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit. c. Tighten the four bolts. 6. Adjusting Inner Armpost Fit a. Two set screws are installed in the outer armpost. b. Turn the set screws in or out until the desired fit is achieved. 4 3 8 5 10 & 6 33 1 Height-Adjustable Armrest Key 1. Outer armpost 2.
IX. 34 Set-Up, Adjustment O. STRUT TUBES 1. Width Adjustment a. Replace the three strut tubes and release bar with larger or smaller sizes. Strut tubes and release bars are available from your authorized supplier. NOTE ON WIDTH ADJUSTMENT– Size changes may require a larger seat insert and footplates. 15" and 16" widths receive adult hangers. P. CHECK-OUT After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also perform smoothly.
36 X. Operating Guide Your chair has a thermal roll-back circuit. This protects the controller from damage due to overheating. In extreme conditions (such as repetitive hill climbing) the circuit will decrease the power to your motors. This allows the chair to operate at a reduced speed. When the controller cools, the chair will return to normal speed. 37 4. Mode Switch (D) The on/off/mode switch allows you to select from 5 (five) different programmable drive profiles or actuator mode sets.
X. 38 Operating Guide XI. Batteries 39 A. INTRODUCTION 1. Never use the ON/OFF switch to stop your chair except in an emergency. This will result in an abrupt stop and may cause you to fall. 2. To slow or stop your chair, return the joystick to neutral. F. MOTOR LOCKS Disconnect the motor locks when you need to manually push the chair. (For example, in an emergency, or if batteries fail). 1. Do not disengage motor locks unless power to the chair is off. 2.
XI. 40 Batteries • Never unplug charger by pulling on the electrical cord. This will damage the cord. • Never open a charger or attempt to repair it yourself. Return charger to Sunrise or have repairs made only by a qualified person. • Keep cord out of the way, where it will not be stepped on, tripped over, or damaged. 3. Caution — To Avoid Damage to the Battery: • Make sure you use the correct setting for sealed (gel) batteries (located on the off-board charger). • Never charge a frozen battery.
XI. 42 Batteries To avoid the risk of severe injury or death from electrical shock, fire or explosion while charging: 930578 Rev. A Batteries 43 5. Make sure to allow enough time to fully charge batteries. NOTE– Batteries should never be left for long periods in the discharged state. Unused or stored batteries should be given a charge once per month. 6. Charge batteries by engaging the battery charger connector (A) to the charger/programming port (B) located on the joystick. E.
XII. 44 Maintenance A. NOTES 1. Proper maintenance will improve performance and extend the useful life of your chair. 2. Clean your chair regularly. This will help you find loose or worn parts and will make your chair easier to use. 3. To protect your investment, have all major service and repair work done by your supplier. 1. Your chair needs regular maintenance for peak performance and to avoid injury from chair failure, damage or premature wear. 2.
XII. 46 3. CAUTION– To prevent tire damage: •Use a hand pump (or a low volume air pump) to inflate tires. •Use a tire gauge to check pressure. F. TO REPAIR OR REPLACE A TIRE Maintenance XII. Maintenance 47 G. MOTOR BRUSHES Check the motor brushes every four (4) months for wear. The brushes should be clean and shiny. Replace worn or blackened brushes. H. ORDERING PARTS When you order parts, provide the following: Residual air pressure in tires can cause severe injury.
48 XIII. Wiring Diagram X I V. Sunrise Limited Wa r r a n t y 49 1. FOR LIFE We warrant the main frame of this wheelchair against defects in materials and workmanship for the lifetime use of the first consumer purchaser. 2. ADDITIONAL WARRANTY We warrant Sunrise-made components of this wheelchair against defects in materials and workmanship as follows: a. Main electronic controller—For two (2) years from the date of first consumer purchase. b.
Sunrise Medical 7477 East Dry Creek Parkway • Longmont, Colorado • 80503 USA (800) 333-4000 In Canada (800) 263-3390 © 2002, Sunrise Medical 12.
