Instructions / Assembly

QuickJack™ Portable Car Jack 15 P/N 5900959 — Rev. J3 — Oct. 2019
Setup
This section describes how to set up your QuickJack.
⚠ WARNING Use only the factory-supplied parts that came with your QuickJack . If
you use parts from a different source, you void your warranty and compromise the
safety of everyone who sets up or uses the QuickJack. If you are missing parts, visit
quickjack.com/support or contact QuickJack Technical Support at
[e-mail], [phone], or [phone].
Your QuickJack is supplied with setup instructions that meet the criteria set by the American National
Standard “Automotive Lifts – Safety Requirements for Construction, Testing, and Validation” ANSI/ALI
ALCTV-2011.
Setup Safety Rules
When setting up a QuickJack, your safety depends on proper training and thoughtful operation.
⚠ WARNING Always use proper tools, such as a forklift or shop crane, to move heavy
components. Do not install this equipment without reading and understanding this
manual and the labels on the unit.
BendPak recommends referring to the ANSI/ALI ALIS Standard (R2015) Safety Requirements for
Installation and Service for more information about safely setting up, using, and servicing your
QuickJack.
Pay attention at all times during setup. Use appropriate tools and equipment. Stay clear of
moving parts. Keep hands and fingers away from pinch points.
⚠ WARNING You must wear protective equipment at all times during setup: leather gloves, steel-
toed work boots, eye protection, back belts, and hearing protection.
Tools
You need the following tools to set up your QuickJack:
• SAE / metric hex key set
• SAE / metric socket and ratchet set
• SAE / metric wrench set or an adjustable wrench
• Screwdriver set
Tip Keep a rag handy during setup; Hydraulic Fluid sometimes leaks.
At some point during setup, you will need to provide some air pressure (to 50 PSI, for the Air Cylinder)
and 2.1 quarts / 2 liters of Hydraulic Fluid.