Instructions / Assembly
Table Of Contents
- QuickJack Manual
- Table of Contents
- Introduction
- Shipping
- Safety
- Components
- Accessories
- Specifications
- Frequently Asked Questions
- Setup Checklist
- Setup
- Setup Safety Rules
- Tools
- Selecting a Site
- Unpacking
- Clearances
- QuickJack Assembly Kit
- Air and Hydraulic Cylinders
- Installing the Hydraulic Elbow Fittings
- Preparing the Short Hydraulic Hoses
- About Quick-Connect Fittings
- Routing the Short Hydraulic Hoses
- Preparing and Connecting the Long Hydraulic Hoses
- Pressurizing the Air Cylinders
- Find a Location for the Power Unit
- Installing the Hydraulic Fittings on the Power Unit
- Connect the Power Unit to a Power Source
- Filling the Hydraulic Fluid Reservoir on the Power Unit
- Check the Breather Valve
- Connect the Hydraulic Hoses
- Bleeding the Hydraulic Cylinders
- Final Checklist Before Operation
- Test the QuickJack
- Leave the Manual with the Owner/Operator
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Sheets
- Automotive Lift Institute (ALI) Store
- Maintenance Log
- CE Documentation
QuickJack™ Portable Car Jack 17 P/N 5900959 — Rev. J3 — Oct. 2019
Unpacking
Open the boxes and arrange the QuickJack components where you will be setting them up.
⚠ WARNING Your two QuickJack Frames are similar, but they are
not
interchangeable. Always
line up your Frames as parallel to each other as the Lifting Points will allow, with the
Lock Bars on the outside
, as shown below.
⚠ CAUTION Be sure to route the Short Hydraulic Hoses
under
the QuickJack Frames. If they
are routed over the QuickJack Frames, the QuickJack will not work correctly and
the Hoses could be damaged.