Instructions / Assembly

QuickJack™ Portable Car Jack 44 P/N 5900959 — Rev. J3 — Oct. 2019
Lowering the Frames from the Top Locking Position
Lowering the QuickJack’s Frames from the Top Locking Position is different from lowering them from
the First Locking Position, so it is described separately.
⚠ WARNING When lowering QuickJack Frames, make sure the Lock Bar and the Release Cam
stay in their Lock Channel. If they get knocked sideways they can get stuck on the
rail of the Lock Channel, which results in the QuickJack not lowering correctly.
To lower the QuickJack Frames from the Top Locking Position:
1. Press and hold Up until the Lock Bar is off the Lock Block, then release Up.
2. Raise the Lock Bar
on both QuickJack Frames so that the Release Cam is on top of the Lock
Block on both Frames, as shown below.
You can use your hand or your foot to raise the Lock Bar.
Not necessarily to scale. Not all components shown. Release Cam shown on top of the Lock Block
for the Top Locking Position.
3. When the Release Cam is on top of the Lock Block on both Frames, press and hold Down until
both QuickJack Frames lower to the ground.
If the Lock Bars engage on the Lock Block as the Frames go back down, start the process over
again.
If one side re-engages on the Lock Block but the other does not, immediately release Down and
then start the process again. If this issue continues, refer to Troubleshooting.
Note: QuickJack recommends pressing Down for ~5 seconds
after the Frames are on the
ground; this ensures that as much Hydraulic Fluid as possible returns to the Fluid Reservoir.
4. Remove the QuickJack Frames from underneath the Vehicle; you may want to use the Quick
Frame Handles.
5. Move the Vehicle, if desired.
Do not drive the Vehicle on the QuickJack Frames or the Hydraulic Hoses.