Installation Guide

10
2018_0202_QS_LOW_INST
Quick Step Studio Horizontal Accent Wall Install Instructions
9. Drive a brad nail into each plank at each wall stud through the shallow area of the extended groove (see inset
diagram). Take care that the brad nail heads are not raised, but also don’t force them all the way through the
groove. This will allow easy connection of the next row of planks. You must also place drywall screws every 16" into
the wall studs or sill plate along the bottom edge of the first row of planks where they will be covered by the wall
base. (Figure 4)
10. Start the second row from the right side. Cut and glue with silicone adhesive caulk the first plank. Fit plank by
angling tongue into groove and wiggle into place. Use tapping block as needed. Drive a brad nail into each plank
through the shallow area of the extended groove at each wall stud. (Figure 5)
NOTE: A joint “stagger” of 8 to 12 inches looks most natural. Avoid allowing plank ends to align.
11. Plank 2 of row 2 (and each plank thereafter in row 2) will be modified by removing the short end tongue. Score the
tongue with a utility knife 3 – 4 times to remove. You will now have a square end. (Figure 6)
12. Apply silicone adhesive caulk in an “S” pattern and install modified boards by tilting into place. Tighten joints as
needed with a tapping block or pull bar. Drive a brad nail into each plank through the shallow area of the extended
groove at each wall stud. (Figure 7)
brad
nail
4
stagger
8-12"
5
remove
6
Plank 3 Row 2
7