Installation Guide

2. Door guide bolt method (part number HA.404.19.11B) (see figure 4a)

(This method involves using the door guide bolt along with a groove cut in the skirting trim of the furniture/

cabinet located below the door)

a) Drill a 35mm hole centered in the back of the door. The center of the 35mm

hole should be ½” up from the bottom edge of the door and drilled to a depth of ½”.

b) Install the door guide bolt into a 35mm hole in the back of the door. Secure the

door guide bolt to the door using pressure fit, glue, or screws.

Step 3: Securing the bottom of the Doors (from moving in and out)

There are a variety of ways that to accomplish this. Below are two possible methods.

1. Channel method (see figure 3)

a) Within the furniture piece or cabinet design, incorporate a bottom channel the

door will ride in. This channel should be slightly wider than the door and deep enough to

firmly keep the door in place.

b) Add one strip of felt or vinyl to the back of the door that sits in the channel

and another piece to the inside front of the channel. This will allow the door to run

smoothly within the channel.

Figure 3