Installation Guide

OPTIONAL: Soft-Close Mechanism Installation

Although the soft-close mechanism can be installed after the rail has been mounted, it is

much easier to access the small set screws that secure the mechanism to the rail prior to

mounting the rail.

For the soft-close mechanism to operate correctly, the gap between the top of the door

and the bottom of the rail must be ¼”.

1. The soft-close mechanisms come as a pair, left and right, so be sure to install the

mechanism in the correct orientation (see figure 5a).

2. Determine the location of the soft-close mechanism on the rail (approximately above

the middle of the door where the door will be in the stopped position).

3. Using the supplied 2mm Allen wrench, secure the mechanism onto the rail by

tightening all four set screws (figure 5b).

Figure 5a

Figure 5b