Installation Guide

8. Push the door until the soft-closer “grabs” the door and softly closes it. Adjust the

position of the actuator, if necessary, to soft-close the door.

Note: It is also critical that the actuator is positioned in such a way that, when opening the door, the soft-close

mechanism returns and stops in the “loaded” position, ready to engage with the actuator when the door is to

be soft-closed again.

7. Reinstall the door (figure 5f). With the soft-close mechanism in the “loaded” position,

move the door until the actuator meets the soft-closure. Verify that the actuator is

in the correct position on the door so that the actuator fully engages the soft-close

mechanism (figure 5e).

Loosen the rail screws near the soft-close

mechanisms to make it easier to reinstall

the door.

Install the door on the rail and re-tighten

the screws.

Figure 5e

Figure 5f