Installation Guide

4
Step 2: Installing the Hardware on the Doors
(Door thickness range = 1 ⅜” -1 ¾”)
1. Installing BiFold butt hinges on the back for the doors
(figure 3)
a) Lay the doors to be joined together face down on a
flat surface.
b) Butt the doors together with a ⅓” gap in between
(approximate thickness of 3-4 business cards).
c) Space the hinges approximately 10”-12” down from
the top and up from the bottom of the doors.
d) Align the hinge knuckle parallel and directly over the
joint between the two doors. Using a self-centering
#9 Vix bit or a ⅛” drill bit, predrill the fastener holes.
e) Secure the hinges to the door with the supplied flat-
head screws.
2. Installing top connector plate onto the door
a) Top Mount Hardware only (figure 4)
• Mark the location on the top of the door where
the fasteners for the top connector plate will be
installed. Measure in 7/8” and 1-7/8” from the
edge of the door and ¾” from the front of the door.
• Using a 1/8” drill bit, predrill the holes in the top of
the door and install the plates using the supplied
fasteners.
10-12”
10-12”
Figure 3
Figure 4a
⅞”
1”
¾”
Figure 4b