Installation Guide

5
3. Installing the brass sleeve on the bottom of the door (figure 6)
a) The brass sleeve needs to align with the center of the top connector plate used
with the fixed roller.
b) To find the center of the hole, measure 1-3/8” in from the bottom edge of the
door and ¾” in from the front of the door.
c) Using a 5/8” spade bit or Forstner bit, drill a 7/8” deep hole and insert the
brass sleeve.
b) Front Mount Hardware only (figure 5)
• Measure 1-3/8” from the front edge of the door and scribe a vertical line
5-1/2” down from the top of the door (parallel with the side edge of the door).
• Scribe an intersecting line 1-9/16” and 5-1/8” down from the top of the door
for the center hole position of the fasteners.
• Drill 3/8” through holes in the door for the fasteners and drill 1/8” holes on the
top of the door for the top plate.
• Mount the front mount top connector plates to the door with the supplied
screws, lag bolts, washers, and acorn nuts.
Figure 5a
Figure 6a
Figure 5b
Figure 6b
drill out
10
drill o ut
10
5⅛”
1⁄”
1⅜”
23mm
Ø15
drill o ut
15
23mm
Ø15
drill o ut
15
1⅜”
¾”