Installation Guide

6
2. Lift the doors up close to the wall and pull forward to engage the top connector plate
on the top of the door with the fixed roller and adjustable roller (see figure 8a) .
(be sure the set screw on the side of the fixed roller and adjustable roller is backed out
so that it does not protrude into the slot opening)
3. Using the supplied 2mm Allen wrench, tighten down set screws to lock the fixed and
adjustable roller assemblies to the top connector plates (see figure 8b) . Setting this
screw approximately 3/8” deep will ensure proper holding position of this screw.
4. Slide the doors to the desired location on the rail (figure 8c) .
Step 3: Hanging the Doors on the Rail (figures 7, 8a, 8b, 8c)
In order to determine the proper location for the bottom pivot plate, the doors must first be
hung on the rail at the desired position in reference to the opening.
(Door thickness range 1 ⅜” - 1 ¾”)
1. Hang the fixed roller and the adjustable roller in the correct positions on the rails
(figure 7) .
Figure 7
Figure 8a Figure 8b
Figure 8c
Fixed Roller
Adjustable Roller