Installation Guide

7
5. To maintain this desired position on the rails, secure the fixed roller to the rail.
a) Slide the fixed roller lock bracket onto the rail directly behind the set screw
located on the front of the fixed roller (figure 9a) .
b) Using the supplied 2.5mm Allen wrench, tighten the set screws on the back of
the fixed roller lock bracket (figure 9b) .
c) Lock the fixed roller onto the rail by tightening the 1” long set screw (using the
2.5mm Allen wrench) through the fixed roller strap, through the fixed roller lock
bracket and into the rail (do not over tighten). Using a 13mm open end wrench
or 13mm socket wrench, tighten the hex-head nut onto this set screw (figures 9c
& 9d) .
Figure 9b
Figure 9d
Figure 9a
Figure 9c