Installation Guide

8
Step 4: Installing the Bottom Pivot Plate
The location of this bottom pivot plate is critical for the proper functioning of the Bi-Fold Barn
Door.
1. Pull out the bottom of the door slightly and insert the bottom pivot plate (figure 10a) into
the brass sleeve located in the bottom of the fixed position door, reposition the door.
2. Using a quality level, plumb the door and mark the position of the bottom pivot plate on
the floor (front edge and outside edge - see figure 10b).
3. Take the fixed pivoting door off of the rail by removing the set screw on the fixed roller
and pushing the door inward towards the wall until the top connector plate disengages
from the fixed roller assembly.
4. Reposition the bottom pivot plate on the marks made in step 2 of this section. Move the
plate slightly forward from the mark (approximately 1/16”) and secure to the floor using
the supplied screws (figure 10c, 10d)
(moving the bottom pivot plate forward slightly helps to keep the doors butted together
in the closed position)
Figure 10a
Figure 10c
Figure 10b
Figure 10d