Installation Guide

Center Guide Installation
1. Route a ¼” wide by ½” deep groove, centered in the bottom of the
door.
2. Install the door onto the rail.
3. With the door hanging in the correct position on the rail (plumb and
square to the wall, with a consistent gap between door and wall. Make
a mark on the floor that lines up with the center of groove on the
bottom of the door.
4. Locate the door guide along the line marked on the floor so that the
door guide is engaged in the groove in the door when the door is both
in the closed position and opened position.
5. Secure the door guide to the floor with the supplied fasteners