Ladder Installation/Specification Guide
General Installation/Specification Guide Step 1: Rail Installation Special application notes: � Leave at least 7” of clearance between the center of the rail and the ceiling, crown moulding or other overhanging protrusions when the ladder is in the stored position (close to the wall/cabinet/bookshelf). In the climbing position, a minimum 3” clearance between the center of the rail and any upper cabinet doors is required to be able to open the upper cabinet doors.
5. Once all the steps are assembled onto one of the side rails, position the side rail on its side with the steps pointing up. 6. Apply a thin film of glue on the ends of each step and in the dado of the other rail, along with the holes in the sides of the rail (for the top turned rung) and the ends of the top turned rung. 7. Properly align each step as well as the top turned rail into its corresponding dado/hole, use the supplied 1-3/4” washer-head screws to fasten the steps into place. 8.
Bottom Ladder Hardware Top Ladder Hardware Top Roller 7/8” Rolling Hook 4” CC 5-1/2” 2-1/8” dia 6-1/2” 4” CC 5-1/2” Brake Wheel 7/8” 6-1/2” 2-1/2” 1-3/4” 2” dia 8-1/4” 1-3/4” 5-1/2” 4” Double Hook * 1-3/4” Adjustable Hook 53/64” * 7/8” 6-1/8” 7/8” Standard Wheel 1-3/16” 1-3/8” 6-1/2” 4-13/16” 5-1/2” 4-13/64” 4” CC 8” 1-3/4” 3-7/8” 3-5/16” 27/32” 7/8” * Designed For Loft Applications Top Swivel Roller 5-7/8” 7/8” Contemporary Wheel Non - Skid Foot 1-7/16” 1-1/4 5-1/
Curved rail radius dimensions 1-3/8” Hook top Hardware cannot be used with curved rails! Bracket Splice kit Rail Diameter = 1” 90° Bracket Rail Height & Ladder Distanc Vertical Rail Brackets For Roller and Swivel Top Guides s iu 0” 3 d Ra 7/8” 2”CC 2-5/8” 115” Straight section of curved rail 14 1-3/4” 2” 103” / -1 Rail heights ( center of Rail ) 6” Protrusion 91” 2-3/8” 23/32” 38” For Hook and Rolling Hook Top Guides 15/16” 8’ 135° 21.
Make your own Ladder 45-Degree Bevel To determine length of ladder: Measure from the center of rail to the floor, then add five inches to the measurement. 7/8” Dia x 1/2” Deep Hole. 15-3/8” and 19-3/8” OAL 14-3/8” and 18-3/8” Inside 1-1/4” Dia. to 1-1/8” Dia.
