Instructions / Assembly

Rolling Door Hardware

A. Face-mount roller strap

1. The distance between the top of the door and the outer diameter of

the wheel should be 1-7/8” (this will achieve approximately 3/32” gap between

the top of the door and the rail),

2. Using the fasteners provided, attach the strap to the door.

Side to side placement of the straps is based on the aesthetic look

desired. The screws must be installed into solid wood, not

recommended for hollow-core doors. It is recommended that the

screw holes in the door are predrilled.

3. Make sure that proper vertical alignment of the strap is achieved

before fastening the strap to the door.

Installation Instructions

Rail Installation

Rails must be mounted into solid wood (framing studs, header or securely attached trim).

1. The location of the rail is dependent on the height of the door, desired gap between the  oor

and the bottom of the door and the desired over lay of the top of the door to the door opening.

2. Recommended spacing for the wall mounting brackets is approximately 16”

3. On the wall determine the desired location of the mounting brackets (p/n QG.FR201.08)

4. Transfer the location of the studs and mounting brackets to the backside of the rail by placing

the rail  at on the wall and marking the stud/bracket locations on the back of the rail.

5. Use mounting bracket as a guide (as shown in picture) to hold the drill bit from “walking”, drill

the mounting hole in the center groove of the rail.

6. Mount the rail to the wall using the lag bolts and washer provided in the kit.

1-7/8”

}

Roller Strap

installation

Center Guide Installation

1. Route a ¼” wide by ½” deep groove, centered in the bottom of the door.

2. Install the door onto the rail.

3. With the door hanging in the correct position on the rail (plumb and square to the wall, with a consistent

gap between door and wall. Make a mark on the  oor that lines up with the center of groove on the bottom of

the door.

4. Locate the door guide along the line marked on the  oor so that the door guide is engaged in the groove in

the door when the door is both in the closed position and opened position.

5. Secure the door guide to the  oor with the supplied fasteners

Transfer the location of the studs and mounting brackets to the backside of the rail by placing

Recommended Rail

Positioning Formula

Centering guide

PAGE 1
Rolling Door Hardware Installation Instructions Roller Strap installation A. Face-mount roller strap 1. The distance between the top of the door and the outer diameter of the wheel should be 1-7/8” (this will achieve approximately 3/32” gap between the top of the door and the rail), 2. Using the fasteners provided, attach the strap to the door. Side to side placement of the straps is based on the aesthetic look desired. The screws must be installed into solid wood, not recommended for hollow-core doors.
PAGE 2
Door Stop Installation 1. With the straps installed on the door, slide the door onto the rail that is installed on the wall. 2. Position the door in the desired location for the closed position. Place the door stop (p/n QG.FR40.08) against the rail and the door. Mark the location of the mounting hole. 3. Now position the door in the desired location for the opened position. Mark the location of the mounting hole. 4. Using a 5/16” drill bit drill the holes for the door stop bolts. 5.