Installation Instructions

3. Fold the heating panel so that it runs level between the two joists
and nail or staple the other side into position.
4. Repeat for each heating panel set, then continue to the next sec-
tion, Wire the Heating Panel Sets.
INSTALLATION
9
NOTE
Aligning heating elements in this way provides a 2 inch / 50 mm air
gap above the heating panels. This air gap is required for the proper
operation of the Warm Floors System.
Fold heater up to opposite joist
CM1004 FLOOR - 2003-09-16.qxd 9/17/2003 2:59 PM Page 11