Installation Guide

QUIETCOOLSYSTEMS.COM 7

WELCOME

INSTALLATION

WIRING OPERATION

WARRANTY

2.2 INSTALLING AFG VENT COVERS

Included with your QuietCool Attic Gable Fan are four vent covers

that are designed to be installed around the attic fan housing to

block any air backdrafting into the attic through a gable vent that

is larger than the attic fan cylinder, causing air to cycle in and out

around the vent.

1. Take the vent cover and match it to one of the sides around

the attic fan housing.

2. Using the two included Pan Head screws, attach each corner to

the wood framing around your gable vent.

3. Repeat step 1 and 2 for the three additional covers.

Figure 2.1A

Figure 2.1B

3. WIRING

IMPORTANT: Wiring Diagrams are for examples ONLY. Wiring should be done by a licensed

electrician following local building and electrical codes and/or NEC guidelines.

NOTE: Your fan came with the Adjustable Thermostat pre-wired on High Speed to a power cord for

testing purposes before installation. If you would like to hard-wire the fan, or it is required by your

local building codes, please follow the wiring instructions below.

3.1 THERMOSTAT WIRING

1. For this installation, you will need a 2 wire Romex, and a thermostat.

2. Open up the thermostat that is connected to the fan. Remove the power cord. Bring your 2 wire

Romex from the power source into the thermostat.

3. With a wire nut, tie the white common wires together.

4. High Speed: Tie the black wire from the fan to one of the black wires from the thermostat. Cap the

red wire (see Figure 3.1A)

Low Speed: Tie the red wire from the fan to one of the black wires from the thermostat. Cap the

black wire (see Figure 3.1B)

Installation Video:

Watch the video by scanning the QR

code or visit