THE NATURAL CHOICE FOR ENERGY SAVINGS! OWNER’S GUIDE SOLAR ATTIC FANS DO NOT THROW AWAY! SERIAL NUMBER FOR FAN IS LOCATED ON BACK COVER OF OWNER’S GUIDE. RETAIN IN A SAFE PLACE.
GENERAL SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. Read Instructions - All safety and operation instructions must be read. Failure to read and follow instructions as stated in this guide may void applicable warranty. Retain Instructions - The safety and operating instructions should be kept for future reference. Heed Warnings - All warnings should be followed. Follow Instructions - All installation and operating instructions should be followed.
1. SYSTEM OVERVIEW 1.1 INTRODUCTION Congratulations on the purchase of your new QuietCool Solar Attic Fan! The QuietCool Specialty Series was designed for every application imaginable. QuietCool Specialty Series fans dominate the market in energy efficiency. Our Specialty Series works great in practically all climate zones and most homes, mobile homes, and even warehouse buildings! Solar attic fans work by using sunlight to power the fans motor to help prevent any heat or moisture build up in your attic.
1.3 System Venting Requirements VERY IMPORTANT! - 1 SQUARE FOOT OF NET FREE VENT AREA PER 750 CFM RECOMMENDED! - 2 TO 4 SQUARE FEET OF INLET VENTS PER FAN Venting plays a very significant role in the performace of QuietCool fans. QuietCool recommends a minimum of 1 SQ. FT. of venting for every 750 CFM in the QuietCool system. If an attic has at least 1:750 attic venting, the QuietCool system will operate efficiently and effectively.
2. INSTALLATION 2.1 Installing AFG SLR model fans Installation Video: Watch the video by scanning the QR code or visit www. QuietCoolSystems.com/ support NOTE: The AFG SLR model fans are designed to mount behind existing vents. If no Figure 2.1A vent exists, one must be installed. Vent should be installed in the upper center section of the gable. NOTE: The mounting brackets for the AFG SLR model fans are on sliding rails.
READ BEFORE ATTEMPTING TO INSTALL AN AFR SLR FAN OR THE AFG SLR SOLAR PANEL Getting Started Always follow Local Building Codes because the fan may require specific fasteners or anchoring systems not discussed in this installation guide. Installation should be done by a licensed roofing contractor. Safety Information Safety precautions should be taken when performing the roofing work described in this installation guide.
2.2 Installing AFG SLR Solar Panel Once you have found a location for your AFG SLR solar panel, now it’s time to mount the panel. The wiring from the solar panel is 30 feet long and must connect directly to the AFG SLR. Make sure the location you have chosen is within 30 feet of the AFG SLR. 1. Attach the provided screws and brackets to the solar panel. Install the angle adjustment brackets by securing one end to the regulating plate and the other end to the solar panel frame. 2.
CAUTION THE AFR SLR-30 AND AFR SLR-40 COME PRE-WIRED WITH THE SOLAR PANEL ATTACHED. THE FAN WILL TURN ON AUTOMATICALLY WHENEVER THE SUN SHINES ON THE SOLAR PANEL. DO NOT REMOVE PAPER COVER THAT IS LOCATED ON THE SOLAR PANEL UNTIL THE INSTALLATION IS FINISHED. REMOVAL OF THE COVER CAN CAUSE UNINTENDED INJURIES IF THE FAN TURNS ON DURING INSTALLATION. 2.3 Installing AFR SLR model fans 1. Determine in which area you would like to install your QuietCool Attic Roof Mount Fan.
3. Go to the roof. Using the screw as a reference point, trace out a 14” diameter circle. 4. Use a reciprocating saw to cut out the traced hole pattern from the roof decking. Remove the cut out decking material from around the hole as needed. (See Figure 2.3B) 5. If you have a shingle roof, insert the reciprocating saw sideways between the shingles and roof decking.
3. WIRING 3.1 Connecting the AC/DC Smart Inverter Your QuietCool Solar Attic Fan includes an AC/DC power inverter. This inverter is used to run the solar attic fan at nighttime when there is no sunlight. Simply plug the solar inverter from your fan into a 110v outlet in your attic. The Smart Inverter will automatically switch between AC power and DC solar power depending on the level of sunlight present. If you do not want to use the AC/DC Smart Inverter, simply leave the fan unplugged.
15 YEAR LIMITED WARRANTY QuietCool Solar Attic Fans SOLAR ATTIC FANS LIMITED WARRANTY QC Manufacturing Inc. extends this warranty to the original purchaser of the following QuietCool Solar Attic Fans - AFG SLR-30, AFG SLR-40, AFR SLR-30, and AFR SLR-40 installed and used in a residence under normal conditions within the United States: A. Five year coverage applies to the QuietCool motor.
QuietCool is Proudly Designed and Built in California Fan Serial Number Information Retain for your records. Serial number is required for warranty purposes. 26040 Ynez Rd., Temecula, CA 92591 // PH 951.325.6340 // QUIETCOOLSYSTEMS.