Installation Guide

10
QUIETCOOLSYSTEMS.COM
Figure 2.5E Figure 2.5F Figure 2.5G Figure 2.5H
4. From the interior, drill a hole through the exterior at the four corners of the cut out (see Figure 2.5A).
5. Go to the exterior and place the square wall mounting bracket aligned to the 4 drilled holes. Using a level,
mark the inside of the bracket with a pencil (see Figure 2.5B).
6. Using a saw or angle grinder, cut out the marked area of stucco or siding (see Figure 2.5C).
7. Remove cut out of exterior stucco or siding. Then cut out any applicable sheathing.
8. Now install the exterior cover frame. Make sure the frame is level and then attach the four corners with
long enough screws to penetrate the wood studs. Note: Predrilling may be required (see Figure 2.5D).
9. Place fan into the cut out area. Fasten the fan in each 4 corners to the vertical wood studs (see Figure
2.5E).
10. Caulk exterior around frame (see Figure 2.5F).
11. Attach the exterior cover to mounting frame using 4 sheet metal screws (see Figure 2.5G).
12. Mount inside wall grille (see Figure 2.5H).
Figure 2.5A Figure 2.5B Figure 2.5C Figure 2.5D