Installation Instructions

1-888-QUIETCOOL

Setting the Hub to Wi-Fi Station Mode:

Step One: From the fan page, tap the Settings gear icon and choose the Network option. Tap the

Wi-Fi setting and tap the Wi-Fi mode option. Change this option to Station mode.

Step Two: Tap the Network option. Type in your Wi-Fi network name. This is case sensitive and must

be typed in correctly. Type your password into the Password field and choose the security type of

your router. (WEP is common, but check the settings of your router) Tap Save.

Step Three: Go back to your device’s Wi-Fi settings and connect to your home Wi-Fi network. Close

out of the QuietCool app and relaunch the app. You should now see your fan in the list of fans.

Adding another Fan to the Network

Adding another fan to your QuietCool network is very easy.

Step One: Tap the + button or the Add new fan button in the QuietCool app. Then tap the Listen

button.

Step Two: On the Hub, click the Join button. Within 30 seconds to a minute you should see the new

fan on your list of devices.

Step Three: Tap the new fan that states “Setup Required”. On the “Setup Fan Controller” page, you

will set the name of your fan and the speeds. We recommend naming the fan as the room that the

fan was installed in such as “Master Bedroom” or “Living Room”, etc. Set the speed of your fan and

tap save. Both the name of the fan and number of speeds can be set later in the Fan Settings.

Controlling your Fan

To control your fan, tap the desired fan on the Device Management screen.

On the fan screen, you have multiple options:

Countdown Timer:

The circular scroll-wheel is your countdown timer. Rotate the

wheel clockwise to select the amount of time you would like to

run your QuietCool fan (from :30 - 12 hours). If you rotate the

wheel all the way around, you will reach the HOLD option which

will keep the fan on indefinitely until you turn it off.

Changing Fan Speed

Above the time display is where you set your fan speed. If the fan

is a single speed fan, there will be no selection (it will state HIGH).

If the fan is a two speed fan, there will be a HIGH and LOW option.

If the fan is a three speed fan, there will be a HIGH, MED, and LOW

option.

Once you have set your speed and timer, simply tap START to turn the fan

on. These settings can also be adjusted while the fan is running.