Installation Instructions

QUIETCOOLSYSTEMS.COM
4
2. INSTALLATION
2-1 Installing the Hub
IMPORTANT: If you are installing the Hub onto an existing QuietCool fan, be sure
to shut off the power before attempting installation. If you are installing the Hub
onto a new fan, perform all installation steps before plugging in the fan.
Option #1 - Install the Hub directly to the motorhead:
1. Remove the handy box cover on your QuietCool fan.
2. Remove the wire nuts from the power cord and motor wires inside the handy box. Remove
the ground screw.
3. Remove the power cord bushing and power cord. Retain both the bushing and power cord
as you will be using it for the installation of the hub.
4. Remove the four screws that are used to mount the handy box to the QuietCool motorhead.
Retain the four screws as you will be using them to attach the Hub to the QuietCool
motorhead.
5. Using your flat-head screwdriver, open up the Hub.
6. Using your flat-head screwdriver, remove the knockouts shown in the diagrams below.
7. Run the motor wire leads through the large knockout in the bottom of the hub.
8. Using the four screws from the handybox, mount the Hub to your QuietCool motorhead
using the highlighted screw holes below.
Installation Video:
Watch the video by scanning
the QR code or visit www.
QuietCoolSystems.com/
support/wi-fi-smart-control
TOOLS YOU WILL NEED
- Flat-head screwdriver - Phillips screwdriver - Power-drill - Philips bit