Instructions / Assembly
1-888-QUIETCOOL 12
2. Secure the Flash Mount to the roof. Finish sealing around the Flash
Mount and ash it into the roof to make a nice seal. If using peel and
stick to ash the ash mount, be sure to not apply too high on the
ash mount so it does not interfere with the plenum box when sliding
the box over the ash mount. (See Figure 2.5C) Take the plenum box
and slide the Flash Mount lip into the plenum box. (See Figure 2.5D)
3. Adjust the plenum box legs to position the plenum box properly on
the roof. Using roong fasteners, fasten the plenum box to the roof.
(See Figure 2.5E)
4. Apply weatherproof sealant to the plenum box legs. (See Figure 2.5F)
5. Remove the duct collar from the fan unit. (See Figure 2.5G)
6. Position the fan on it’s side. Remove the power cord from the RF Control Hub and remove the ex
connector from the RF Control Hub (see Figure 2.5H). Using tin snips, cut the metal out from around the
fan ex (See Figure 2.5I). Using the ex connector, run the fan ex into the junction box on the bottom
oor of the plenum box. Remove junction box plate cover and tie wires together by matching the colors
(See Figure 2.5J). Re-install the plate cover.
7. Lifting the fan unit up at an angle, apply weatherproof
sealant to the bottom side of the fan unit. This will
ensure nice and tight seal. (See Figure 2.5K)
8. Position the fan over the circle fan hole in the
plenum box. Remove the roof cap. Using the 8
supplied hex-head screws with rubber-bonded
washers, attach the fan unit to the plenum box. Be
sure to seal around the screw head. These screws
should be installed as shown in Figure 2.5L so that 6
of the screws are installed into the bracing of the
plenum box.
Figure 2.5H Figure 2.5I Figure 2.5K
Figure 2.5B
Figure 2.5D Figure 2.5F
Figure 2.5G
Figure 2.5L
Figure 2.5C
Figure 2.5E
Figure 2.5J