Installation Guide

Owner’s Manual
Set-Up --Step 1: Place the canopy
frame only in the center of the setup area.
With a partner on the opposite side of
the frame, hold the two outer legs and
lift slightly for ground clearance. Take a
few steps back and extend the frame to
full arm’s length, approximately four
feet (Fig. A).
Step 2: With a partner hold the top and bottom of the eave
where it forms a "V" (Fig. B). Lift slightly and slowly walk backward
until the frame is fully extended (Fig. C). Take care to avoid
pinching your hands or fingers.
Step 3: At each corner, hold the leg of the frame
with one hand and lift the slider with the other
hand until it clicks past the spring pin (Fig. D).
Step 4: Place the canopy over the top
of the frame. Use the hook and loop
straps to secure each corner of the
cover to the upper portion of each leg
(Fig. E).
Step 5: The adjustable legs offer multiple
height positions. Tilt one side of the canopy
upward and extend a lower leg section until
it clicks into place (Fig. F). Repeat on the
adjacent leg until all legs are extended.
When extending the legs, have a partner
hold the frame stable and avoid having
only two diagonal legs extended.
Go to BravoSportsCorp.com/ServiceProductRegistration.aspx
and register your new canopy. If you have any issues setting
up your canopy, have questions, need parts or accessories
call our toll free service line [phone].
Step 6: Fill out included product information card with a
stapled copy of your receipt and store in a safe place.
Product information can be found on the sticker located on
the eave of the frame (Fig. G).
Please review the following instructions and make yourself
familiar with the parts and function of your Shade Tech® canopy.
Parts included:
[1] assembled canopy frame
[1] storage bag
[1] fabric canopy top
A
Take Down --Step 1: Press
the leg pin in and lower each
leg completely (Fig. H).
Step 2: At each corner, push in the
locking button and pull the slider down
slowly until the button pops out above the
slider (Fig. I). Be careful to not pinch your
fingers. Please make sure that all sliders are
in an unlocked position below the button
prior to attempting to collaspe the frame.
Closing the frame with any sliders in a
locked position will cause damage
and/or breakage.
Step 3: Hold the top of the center frame section and lift
slightly and slowly, walk toward your partner as the frame folds
in (Fig. J). Keep walking until the frame is about half-way
closed. Be sure to avoid pinching your hands or fingers. Hold
outside legs and continue closing canopy as you walk towards
your partner. The completely folded canopy should stand up
on it’s own (Fig. K).
Note: The canopy top may remain in place for easier
subsequent set-up. However, to prolong the life of the
fabric, we recommend that you remove the top when
storing your canopy.
Step 4: With the canopy standing, slide the bag down
slowly until entire canopy is in. Turn the canopy over gently
and zipper shut.
B C
E
G
Example
F
D
H
I
K
J
®
Serial No. 0011906
Questions or comments, please call 800-248-5327.
Frame type: 143383 Mfr code: 089LI
Made in China