Installation manual

Fig 3
QK-H300 QK-H400
α = 90° α = 95°° α = 90° α = 95°
B (mm) B (mm) B (mm) B (mm)
A (mm)
min max
A (mm)
min max
A (mm)
min max
A (mm)
min max
100 120 170 120 130 170 110 120 250 120 120 220
110 120 170 130 130 170 120 120 250 130 120 220
140 120 150 150 120 250 160 120 210
L MAX (mm) 1010 200 120 190 210 120 160
210 120 190 220 120 160
220 120 180 230 120 130
230 120 160 240 120 120
Table 1
4- Temporary fix the actuator to the wall and to the leaf (tack weld) and turn the
leaf gate from the close position up to the max. open position (normally 95°) and
check that the leaf turn freely in the hinges and without any swing during its
movement.
5- Provide to complete the assembly of the actuator to the wall and to gate leaf.
6- Connect to the power supply cable 4x1,5 sqmm
7- Proceed with the control board programming (see the CONTROL BOARD
USER MANUAL )
Adjust the actuator thrust acting with the screwdriver on the by pass valves #14