SDS

ManualsBrandsQuikrete ManualsBuilding materials10 lb. Hydraulic Water-Stop Cement

SDS C6 QUIKRETE Companies, LLC 3/11/2019

Page 1 of 11

C6: Portland Cement Based Concrete Products

SAFETY DATA SHEET

(Complies with OSHA 29 CFR 1910.1200)

SECTION I: PRODUCT IDENTIFICATION

The QUIKRETE

Companies Emergency Telephone Number

5 Concourse Parkway, Suite 1900 INFOTRAC (800) 535-5053

Atlanta, GA 30328 Information Telephone Number

(800) 282-5828

Revision: Mar-19

SDS C6

QUIKRETE

Product Name Item #(s)

Fast-Setting Concrete Mix 1004-50, -60

All-Star Fast Setting Concrete Mix 1004-50

Commercial Grade FastSet

Concrete Mix 1004-51

Post Haste 1004-65

Q-MAX Pro Concrete Mix 1004-81

Commercial Grade Fast Setting Pro Concrete Mix 1004-84

All-Star 10 Minute Instant Post Mix 1005-51

Fence & Post Mix 1105-30

FastSet

Water-Stop Cement –Zip & Mix 1121-15

Commercial Grade FastSet

Cement 1124-92

Hydraulic Water Stop 1126-00

Concrete Resurfacer 1131-40

Recap Concrete Resurfacer

Multipurpose Concrete Resurfacer 1131-45

Bonded Topping Mix 1133-04, 1018, 1017

FastSet

Stucco Patch 1139-92

Architectural Finish 1220-55

Commercial Grade FastSet

Repair Mortar – Zip And Mix 1241

Commercial Grade FastSet

Repair Mortar 1241-60

Polymer Modified Structural Concrete – Extended Set 1242-85

Commercial Grade FastSetTM Polymer Modified DOT Mix 1244-54

Commercial Grade FastSet

DOT Mix 1244-56

Commercial Grade FastSet

DOT Deck Repair – Polymer Modified 1244-58

Commercial Grade FastSet

DOT Mix – Extended 1244-81

Commercial Grade FastSet

Non-Shrink Grout 1585-09, -20, -50

Commercial Grade FastSet

All-Crete 1585-59

Mix 801 FastSet

DOT PM Overlay NR801552/80801552

Rapid Road Repair – CA

Summary of content (11 pages)

PAGE 1
C6: Portland Cement Based Concrete Products SAFETY DATA SHEET (Complies with OSHA 29 CFR 1910.
PAGE 2
Product Use: Portland cement-based, rapid-setting materials for general construction or repair. See most current revision of this document at www.QUIKRETE.com. SECTION II - HAZARD IDENTIFICATION Hazard-determining components of labeling: Silica, Portland cement 2.
PAGE 3
easy to do. Continue rinsing. If on skin (or hair): Remove immediately all contaminated clothing and wash before re-use. Rinse skin or hair with water. If significant skin irritation or rash occurs: get medical advice or attention. Immediately seek medical advice if symptoms are significant or persist. Store in a well-ventilated place. Keep container tightly closed. Dispose of contents/containers in accordance with all regulations. 2.
PAGE 4
SECTION III - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION Hazardous Components Sand, Silica, Quartz Portland Cement Calcium Sulfoaluminate Calcium Aluminate Calcium Sulfate Limestone Dust CAS No. 14808-60-7 65997 15 1 65997-16-2 12042-68-1 10101-41-4 01317-65-3 % by Weight 40-70* 10-30* 10-30* 5-10* 1-5* 1-5* *The concentrations ranges are provided due to batch-to-batch variability. None of the constituents of this material are of unknown toxicity. SECTION IV – FIRST AID MEASURES 4.
PAGE 5
Skin burns and irritation may be caused by brief exposure, though often are caused by extended exposure of 15 minutes, an hour, or longer. Interaction of Portland cement with water or sweat releases a caustic solution which produces the burns or irritation. Any extended exposure should be treated as though a burn has occurred until determined otherwise. Skin contact with Portland cement can also cause inflammation of the skin, referred to as dermatitis.
PAGE 6
Do not allow to enter sewers/ surface or ground water. containers properly in accordance with all regulations. Dispose of unwanted materials and SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND STORAGE 7.1 Handling Precautions for safe handling: Ensure good ventilation/exhaustion at the workplace. DO NOT BREATHE DUST. In dusty environments, the use of an OSHA, MSHA or NIOSH approved respirator and tight fitting goggles is recommended. Wear appropriate PPE (See section 8).
PAGE 7
Wear gloves of adequate length to offer appropriate skin protection from splashes. Nitrile, Butyl and PVC gloves have been found to offer adequate protection for incidental contact. Wear rubber boots when stepping in concrete. You cannot rely on pain to alert you to cement burns. Portland cement can cause dermatitis or sensitization. Eye protection: Wear approved eye protection properly fitted dust- or splash-proof chemical safety glasses.
PAGE 8
10.5 Incompatible materials Contact of silica with powerful oxidizing agents such as fluorine, chlorine trifluoride, manganese trioxide, or oxygen difluoride may cause fires 10.6 Hazardous Decomposition or By-products Silica will dissolve in Hydrofluoric Acid and produce a corrosive gas – silicon tetrafluoride. SECTION XI – TOXICOLOGICAL INFORMATION 11.1 Exposure Routes: Skin contact, skin adsorption, eye contact, inhalation, or ingestion. 11.
PAGE 9
SECTION XII – ECOLOGICAL INFORMATION 12.1 Ecotoxicity May cause long-term adverse effects to the aquatic environment. Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system. Must not reach bodies of water or drainage ditch undiluted or un-neutralized 12.2 Persistence and degradability No further relevant information available. 12.3 Bioaccumulative potential: No further relevant information available. 12.
PAGE 10
Not Available 14.2 Transport in bulk according to Annex II of Marpol 73/78 and the IBC Code Not available 14.3 Special precautions for user Do not handle until all safety precautions have been read and understood. SECTION XV – OTHER REGULATORY INFORMATION 15.
PAGE 11
WARNING: This product can expose you to chemicals including crystalline silica which is known to the State of California to cause cancer and Portland cement which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. California Inhalation Reference Exposure Level (REL): California established a chronic REL of 3 µg for silica (crystalline, respirable).