SDS

ONE SECURITIES CENTRE, 3490 PIEDMONT ROAD, SUITE 1300, ATLANTA, GA 30305 SDS J4 TEL [phone] WWW.QUIKRETE.COM
Page 4 of 15
SECTION VI – ACCIDENTAL RELEASE MEASURES
6.1 Personal precautions, protective equipment and emergency procedures: Ventilate the area
with fresh air. Refer to other sections of this SDS for information regarding physical and health
hazards, respiratory protection, ventilation, and personal protective equipment.
6.2 Methods and material for containment and cleaning up:
Pour isocyanate decontaminant solution (90% water, 8% concentrated ammonia, 2% detergent) on
spill and allow to react for 10 minutes. Or pour water on spill and allow to react for more than 30
minutes. Cover with absorbent material. Working from around the edges of the spill inward, cover
with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient
absorbent until it appears dry. Remember, adding an absorbent material does not remove a
physical, health, or environmental hazard. Collect as much of the spilled material as possible. Place
in a container approved for transportation by appropriate authorities, but do not seal the container for
48 hours to avoid pressure build-up. Clean up residue with an appropriate solvent selected by a
qualified and authorized person. Ventilate the area with fresh air. Read and follow safety precautions
on the solvent label and SDS. Dispose of collected material as soon as possible.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND STORAGE
7.1. Precautions for safe handling
Keep out of reach of children. Do not handle until all safety precautions have been read and
understood. Do not breathe dust/fume/gas/mist/vapors/spray. Do not get in eyes, on skin, or on
clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Use
personal protective equipment (gloves, respirators, etc.) as required.
7.2. Conditions for safe storage including any incompatibilities
Keep container tightly closed to prevent contamination with water or air. If contamination is
suspected, do not reseal container. Store away from heat. Store away from amines.
SECTION VIII – EXPOSURE CONTROL MEASURES / PERSONAL PROTECTION
8.1 Components with limit values that require monitoring at the workplace:
Ingredient CAS # Agency Limit Type
Ethylbenzene 100-41-4 ACGIH TWA: 20 ppm
Chem Rec TWA: 25 ppm, STEL: 75 ppm
OSHA TWA: 435 mg/m
3
(100 ppm)
OSHA CEIL: 0.2 mg/m
3
(0.02 ppm)
Calcium Oxide 1305-78-8 ACGIH TWA: 2 mg/m
3
OSHA TWA: 5 mg/m3