Instruction manual
QR-25 Series  Quincy Compressor
52201-107, December 2012  4  3501 Wismann Lane, Quincy IL - 62305-3116
SECTION 2  SYSTEM DYNAMICS
Description & Applica-
tion
The Quincy Compressor QR-25 
Series consists of heavy duty 
indus trial, belt driven, single or 
two stage  compressors.   Single 
stage  compressors  are  capable 
of delivering up  to 100 PSIG 
continuously.      Some  single 
stage  compressors  are  capable 
of delivering up  to 150 PSIG 
intermittantly  (with  proper 
controls and modifica tions).  Two 
stage  compressors  can  deliver 
up to 200  PSIG contin uously, 
and up to 250, 350 or 500 PSIG 
intermittently depending upon 
the model, controls and configu-
ration.
Principles of Compres-
sion Cycles 
Single Stage Compressors
During  the  downstroke  of  a 
single  stage  compressor,  air  is 
drawn through an intake valve 
in  the  head  of  the  compressor 
and  into  the  cylinder.    At  the 
bottom of the stroke, the intake 
valve closes and air is trapped in the cylinder.  The air is then compressed 
in the cylinder during the upstroke of the piston.  Total compression, from 
atmo spheric pressure to the final discharge pressure, is accomplished in one 
stroke of the piston.
Two Stage Compressors
During the downstroke of the piston of a two stage compressor, air is drawn 
through an intake valve in the head of the compressor into the low pressure 
cylinder and compressed during the upstroke of the piston.
The compressed air is then released through a discharge valve in the head 
of the  compressor to an intercooler  (usually finned tub ing) where the  heat 
resulting from compression is allowed to dissipate.  The cooler compressed air 
is then drawn into a second compression cylinder, the high pressure cylinder, 
for compression to final pressure. 
From there the compressed air is released through a discharge valve to an 
air receiver tank or directly to a network of compressed air supply lines. In 
one revolution of the crankshaft a compression cycle is completed.
Fig. 2-1 Cross Section of Typical QR-25 
2 Stage Pressure Lubricated Cylinder & Crankcase
Pix 1064










