QT 7.5 Parts Manual

ManualsBrandsQuincy ManualsStationaryQT MAX 7.5-HP 80-Gallon Two-Stage Air Compressor (208V 3-Phase)

Table Of Contents

QT-7.5 Industrial Quincy Compressor

2022207901, June 2018 12

TYPICAL UNIT REPAIR PARTS LIST

(QT-7.5 simplex - horizontal tank - electric motor)

Part Part Part

Qty Number Number Number Description

80 gal. 120 gal.

1 2023101001 2023101401 tank (200 PSI maximum operating pressure)

1 2023907900 2023913803 tank drain valve

1 2023913804 2023913805 service valve

1 2025018507 2025018507 pressure gauge

1 2023710130 2023710130 pressure switch

1 2023913015 2023913015 pressure relief valve (in tank; 200 PSI)

1 2023913610 2023913610 pressure relief valve (in discharge line; 215 PSI)

1 2023914100 2023914100 check valve

4 ft. 2023200507 2023200507 discharge tube

2 2024903708 2024903708 tube ﬁtting, nut with sleeve

1 2021030801 2021030801 belt guard assembly

7.5 h.p.

1 2024200416 drive belt

1 2024208500 motor pulley

1 2024222616 motor bushing

115/230v, 1Ø 200v, 3Ø 230/460v, 3Ø

1 2023000927 2023000904 2023000928 7.5 h.p. motor (ODP)

* 230 volt only

Part Part Part

Qty Number Number Number Description

120 gal. 200 gal.

1 2023102101 113469-200 tank (200 PSI maximum operating pressure)

2 2023301701 2023301701 top plate

1 2023913803 2023913803 tank drain valve

1 2023913805 2023913805 service valve

1 2025018507 2025018507 pressure gauge

2 2023710130 2023710130 pressure switch, 135-175 PSI

1 2023913015 2023913015 pressure relief valve (in tank; 200 PSI)

2 2023913610 2023913610 pressure relief valve (in discharge line; 215 PSI)

2 2023914100 2023914100 check valve

8 ft. 2023200507 2023200507 discharge tube

2 2024903708 2024903708 tube ﬁtting, nut with sleeve

2 2021030801 2021030801 belt guard assembly

7.5 h.p.

2 2024200416 drive belt

2 2024208500 motor pulley

2 2024222616 motor bushing

115/230v, 1Ø 200v, 3Ø 230/460v, 3Ø

1 2023000927 2023000904 2023000928 7.5 h.p. motor (ODP)

* 230 volt only

(QT-7.5 duplex - horizontal tank - electric motor)

Part numbers shown in italics apply to tank mounted units and base mounted units.

The parts listed here are for standard QT-7.5 (up to 175 PSI) units and may or may not be applicable to custom built units. Check with

your local authorized Quincy distributor for parts that can be used for custom built units. Make sure the components you order are rated

within the safe operating limits of your system. If you are doubtful about which components to order, contact your local Quincy distributor.

Part numbers shown in italics apply to tank mounted units and base mounted units.