QT 7.5 Parts Manual

ManualsBrandsQuincy ManualsStationaryQT MAX 7.5-HP 80-Gallon Two-Stage Air Compressor (208V 3-Phase)

Table Of Contents

QT-7.5 Industrial Quincy Compressor

2022207901, June 2018 13

TYPICAL UNIT REPAIR PARTS LIST

(QT-7.5 vertical tank - electric motor)

(QT-7.5 Kohler gasoline engine driven)

Part Part Part

Qty Number Number Number Description

base unit tank unit

1 2023103006 tank (200 PSI maximum operating pressure)

1 2023304200 top plate

1 2023913801 tank drain valve

1 2023913803 ball valve

1 2025018507 pressure gauge

1 2023913015 pressure relief valve (in tank; 200 PSI)

2 2024200717 2024200717 drive belt

1 2024217800 2024217800 engine pulley

1 2024222614 2024222614 engine pulley bushing

1 2021101797 2021101797 belt guard assembly

1 2025008300 2025008300 throttle control (bullwhip cable)

1 2021096001 2021096001 Kohler engine group, 14 h.p. (includes exhaust system & throttle control)

3 ft. 2023200507 discharge tube (3/4" copper tube to be formed by customer)

2 2024903708 tube ﬁtting, nut with sleeve

1 2023913610 2023913610 relief valve (in discharge line; 215 PSI)

1 2023913306 check valve

1 113708-175 pilot (165-175 PSI)

1 2023916401 discharge unloader valve

80 gal. 120 gal.

1 2023103908 2023103301 tank (200 PSI max. working pressure)

1 2023912903 2023912903 tank drain valve

1 2023913804 2023913804 ball valve

1 2025018507 2025018507 pressure gauge

1 2023710130 2023710130 pressure switch (135-175 PSI)

1 2023913015 2023913015 pressure relief valve (in tank; 200 PSI)

4 ft. 2023200507 2023200507 discharge tube (3/4" copper tube to be formed by customer)

2 2024903708 2024903708 tube ﬁtting, nut with sleeve

1 2023914100 2023914100 check valve

1 2023913610 2023913610 relief valve (in discharge line; 215 PSI)

1 2021030801 2021030801 belt guard assembly

7.5 h.p.

1 2024200416 drive belt

1 2024208500 motor pulley

1 2024208500 motor bushing

115/230v, 1Ø 200v, 3Ø 230/460v, 3Ø

1 2023000927 2023000904 2023000928 7.5 h.p. motor (ODP)

Part Part Part

Qty Number Number Number Description

! Pre-formed discharge tubes are available. Contact factory with model & tank size information.

* 230 volt only.

The parts listed here are for standard QT-7.5 (up to 175 PSI) units and may or may not be applicable to custom built units. Check with

your local authorized Quincy distributor for parts that can be used for custom built units. Make sure the components you order are rated

within the safe operating limits of your system. If you are doubtful about which components to order, contact your local Quincy distributor.